Table of Contents
Advertisement
show dhcp
show dhcp
To display the current DHCP settings on point-to-point interfaces, enter the show dhcp command
from privileged EXEC mode.
show dhcp {lease | server}
Syntax Description
lease
server
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Release
11.3 NA
Usage Guidelines
You can use this command on any point-to-point type of interface that uses DHCP for temporary IP
address allocation.
Examples
Following is sample output for the show dhcp lease command:
uBR924# show dhcp lease
Temp IP addr: 188.188.1.40
Temp sub net mask: 0.0.0.0
Temp default-gateway addr: 188.188.1.1
Table 14 describes the significant fields shown in the display.
108
Cisco IOS Release 12.0(7)T
Shows DHCP addresses leased from a server.
Shows known DHCP servers.
DHCP Lease server: 4.0.0.32, state: 3 Bound
DHCP transaction id: 2431
Lease: 3600 secs,
Renewal: 1800 secs,
Next timer fires after: 00:58:01
Retry count: 0
Client-ID: 0010.7b43.aa01
Modification
This command was introduced.
for peer on Interface: cable-modem0
Rebind: 3150 secs
Advertisement
Table of Contents
