Transceivers And Connectors Supported By The Cisco Nexus 2232Tm Fex - Cisco Nexus 2000 Series Hardware Installation Manual

Chapter 2 Using a Fabric Extender with a Cisco Nexus 7000 Series Switch
Figure 2-20
1
2
For more information on this fan tray, see the fan tray specifications in the
Specifications" section on page B-4
descriptions, see
Installing the Fan Tray" section on page

Transceivers and Connectors Supported by the Cisco Nexus 2232TM FEX

The Cisco Nexus 2232TM FEX supports SFP+ Ethernet optical and copper transceivers and optical FEX
Transceivers (FETs) for up to eight fabric uplink connections to the following Cisco Nexus 7000 Series
switch I/O modules:
•
•
•
•
You must use the same transceivers on both ends of the same uplink cable.
To get the fully dedicated 10-Gbps bandwidth through a M1 Series 32-port 10-Gigabit Ethernet I/O
Note
module, connect each FEX to one port in a set of four shared ports on the module (you connect each set
of shared ports to one FEX) and use the shared mode on the I/O module. If you are using the F2 Series
48-port 10-Gigabit Ethernet I/O module (N7K-F248XP-25) or the M2 Series 24-port 10-Gigabit
Ethernet I/O module (N7K-M224XP-23L), you can connect the FEX to any of its ports.
The Cisco Nexus 2232TM FEX also supports RJ-45 connectors for up to 32 downlink connections to
hosts.
OL-19013-05
Back-to-Front Airflow Fan Tray for the Cisco Nexus 2232PP and 2232TM FEXs
Captive screws (2)
Handle used for removing and installing the module
Table D-1 on page
F2 Series 48-port 10-Gigabit I/O module (N7K-F248XP-25)
M1 Series 32-port, 10-Gigabit Ethernet I/O module (N7K-M132XP-12)
M1 Series 32-port, 10-Gigabit Ethernet I/O module with XL option (N7K-M132XP-12L)
M2 Series 24-port 10-Gigabit I/O module (N7K-M224XP-23L)
Table 2-2 lists the transceivers supported by this FEX for its uplink and downlink connections.
3
4
and the "Physical Specifications" section on page
D-2. To replace one of these fan trays, see the
3-20.
Cisco Nexus 2000 Series Hardware Installation Guide
Cisco Nexus 2232TM FEX
Back-to-front airflow indicated by a
black stripe on the front.
Status LED
"Environmental
B-5. For LED
"Removing and
2-19