Cisco Nexus 2000 Series Hardware Installation Manual page 98

Grounding the System
S e n d d o c u m e n t c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m
Figure 3-5
2000 Series FEX.
Figure 3-5
1 ESD ground strap
2 Clip and grounding lug
3 Side view of grounding lug (clip slid behind
screw)
In addition, follow these guidelines when handling these devices:
Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
•
connectors.
Place a removed component board-side-up on an antistatic surface or in a static-shielding container.
•
If you plan to return the component to the factory, immediately place it in a static-shielding
container.
• Never attempt to remove the printed circuit board from the metal carrier.
Caution For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohm (Mohm).
Cisco Nexus 2000 Series Hardware Installation Guide
3-12
shows how to attach the ESD wrist strap to the system ground lug screw for the Cisco Nexus
Attaching the ESD Wrist Strap to the System Ground Lug Screw
Chapter 3 Installing a Cisco Nexus 2000 Series Fabric Extender
1
4 Clip installed (behind screw)
5 System ground connector
5
2
3
4
OL-19013-05