Cisco Catalyst 4500 series Overview page 8

Supervisor Engines
Figure 1-9 Supervisor Engine V-10GE (WS-X4516-10GE)
CONSOLE port
STATUS LED
Compact
Flash
RESET
port
button
Switch load
indicators
Front-Panel Components
Catalyst 4500 Series Module Installation Guide
1-8
Ethernet
management port
10 GE uplink Gigabit SFP
ports
The following connectors, LEDs, and buttons are located on the front panel of the
supervisor engine:
The STATUS LED, which indicates the operating state of the module
•
Two Gigabit uplink ports (WS-X4013, WS-X4013+, WS-X4014, and
•
WS-X4515 supervisor engines only)
Four SFP Gigabit uplinks ports and 2 10-Gigabit uplink ports on
•
WS-X4013+10GE and WS-X4016-10GE.
Eight unmarked switch load indicator LEDs, which provide an approximation
•
of the current traffic across the backplane
A console port (DB-25 for the WS-X4012; RJ-45 for the WS-X4013,
•
WS-X4013+, WS-X4013+ TS, WS-X4013+10GE, WS-X4014, WS-X4515,
WS-X4516, and WS-X4516-10GE supervisor engines)
An Ethernet management port (RJ-45)
•
A link status LED, which provides status for the management port
•
(10BASE-T on the WS-X4012 and 10/100BASE-T on the WS-X4013,
WS-X4013+, WS-X4013+ TS, WS-X4013+10GE, WS-X4014, WS-X4515,
WS-X4516, and WS-X4516-10GE supervisor engines)
Chapter 1
ports
Module Overview and Specifications
78-13267-06