Ws-X4019 - Cisco Catalyst 4500 series Overview

Other Switching Modules
Note
Other Switching Modules

WS-X4019

Catalyst 4500 Series Module Installation Guide
1-42
there is only enough power for 18 powered devices. If the powered devices are
using less than 15.4 W per port, more powered devices can be powered, up to the
312 W maximum. For more information about installing the PEM or the external
power shelf, refer to the Catalyst 4000 Series Installation Guide, Catalyst 4500
Series Installation Guide, Installation and Configuration Note for the Catalyst
4500 Series AC Power Shelf, or the Catalyst 4500 Series Power Entry Module and
External Power Shelf Installation Note.
To provide PoE with the 48-port PoE 10/100/1000BASE-T switching module in
a Catalyst 4500 series switch, you must have an PoE-enabled power supply. All
power supplies support PoE except the 1000 W and 1400 W AC power supplies.
Auto MDIX is not supported on PoE enabled switching modules.
This section describes other Catalyst 4500 series switching modules and includes
the following sections:
WS-X4019, page 1-42
•
Access Gateway Module (WS-X4604-GWY), page 1-43
•
The WS-X4019 backplane channel module (see
specifications:
Specification
Module type
Port duplex mode
Port speed
Number of ports
Chapter 1
Description
Backplane channel module
–
–
0
Module Overview and Specifications
Figure 1-39) has the following
78-13267-06