Ws-X4424-Gb-Rj45 - Cisco Catalyst 4500 series Overview

Chapter 1 Module Overview and Specifications

WS-X4424-GB-RJ45

Note
Figure 1-32 WS-X4424-GB-RJ45 24-Port 10/100/1000BASE-T Gigabit Ethernet Switching Module
24 PORT
10/100 0/BAS E-T
1 1
STATU S
2 3
4
5
6
7
8
9
78-13267-06
The ports on this switching module can be configured with any combination of
shortwave (SX), longwave/long-haul (LX/LH), and long-range (ZX) GBICs. For
a description of GBICs, see the
section on page 2-8.
The WS-X4424-GB-RJ45 24-port 10/100/1000BASE-T Gigabit Ethernet
switching module (see
Specification
Module type
Port duplex mode
Port speed
Number of ports
Connector type
Cable type
You must use Category 5 cables when connecting to the 1000BASE-T ports on
this switching module.
MULIT -SPEE D
GIGAB IT ETHER NET
SWITC HING
MODU LE
10 11
12
13
14 15
16
17
18
19
20
Ports on this switching module may be oversubscribed, depending on utilization.
For further information on these ports, see the
Ports" section on page
"Installing, Removing, and Maintaining GBICs"
Figure 1-32) has the following specifications:
Description
10/100/1000 Fast or Gigabit Ethernet switching
module
Half or full duplex mode at 10 and 100 Mbps; full
duplex mode only at 1000 Mbps
10, 100, or 1000 Mbps
24
RJ-45 (See Figure 2-1 on page
UTP
21 22
23
24
3-9.
Catalyst 4500 Series Module Installation Guide
Gigabit Ethernet Switching Modules
2-2.)
"Configuring Gigabit Ethernet
1-35