Ws-X4448-Gb-Lx - Cisco Catalyst 4500 series Overview

Gigabit Ethernet Switching Modules

WS-X4448-GB-LX

Figure 1-33 WS-X4448-GB-LX 48-Port Gigabit Ethernet Switching Module
WS-444 8-GB-L X
1 3
5
7
9 11
13
15 17
2
4
6 8
10 12
14 16
18
STATU S
2 4 6
8
10 12
14 16
Catalyst 4500 Series Module Installation Guide
1-36
The WS-X4448-GB-LX 48-port Gigabit Ethernet switching module (see
Figure 1-33) has the following specifications:
Specification
Module type
Port duplex mode
Port speed
Number of ports
Connector type
Cable type
19
21 23
25
27 29
31
33 35
37 39
20 22
24
26 28
30
32 34
36
38 40
18 20 22 24
26
28 30 32
34
36 38 40
Ports on this switching module may be oversubscribed, depending on utilization.
For further information on these ports, see the
Ports" section on page
The 48 ports can be configured with any combination of small, form-factor
pluggable (SFP) modules. For a description of SFP modules, see the
SFP Modules" section on page
Problem Insertion of unsupported SFPs (small form-factor pluggable optics) into
a WS-X4448-GB-LX module can cause undetected communication failures
between the supervisor engine and the corresponding module. Subsequent
insertion or removal of SFPs from the module is not recognized by the system.
This activity can be observed on a Catalyst 4500 series switch using Release
12.1(12c)EW1 or later releases.
Reset the module with the hw-module module reset command.
Solution
(CSCee05078)
Chapter 1
Description
1000BASE-X Gigabit Ethernet switching module
Full duplex mode
1000 Mbps
48
LC type (See Figure 2-9 on page
MMF or SMF (LX fiber-optic cable only)
41
43
45 47
42
44 46
48
42 44
46 48
3-9.
2-22.
Module Overview and Specifications
2-6.)
"Configuring Gigabit Ethernet
"Installing
78-13267-06