Interference Or Distortion Appear In Images; The Image Is Truncated (Large) Or Small, Or The Aspect Is Not Suitable - Epson EB-X14 User Manual

Problem Solving

Interference or distortion appear in images

Check
Is the image signal format setting correct?
(Only when projecting images from a video source)
Are the cables connected correctly?
Is an extension cable being used?
Is the correct resolution selected?
(Only when projecting computer images)
g g
Are the Sync. and Tracking settings adjusted correctly?
(Only when projecting computer images)
Is Transfer layered window selected?
(Only when projecting USB Display)

The image is truncated (large) or small, or the aspect is not suitable

Check
Is a wide panel computer image being projected?
(Only when projecting computer images)
Is the image still being enlarged by E-Zoom?
Is the image position adjusted correctly?
Change the setting according to the signal for the connected equipment.
s Signal - Video Signal p.68
Check that all the cables required for projection are securely connected.
s "Connecting Equipment" p.23
If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector to
check if the cables you are using may be causing the problem.
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.102
s Computer's documentation
Press the [Auto] button on the remote control or the [
If the images are not adjusted correctly even after performing automatic adjustment, you can also make adjustments
from the Configuration menu.
s Signal - Tracking, Sync. p.68
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then clear the
Transfer layered window checkbox.
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.68
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
(Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position p.68
Remedy
] button on the control panel to perform automatic adjustment.
Remedy
p.54
] button on the control panel to adjust the position.
83