Stat-One And Stat-Two Commands - HP 39G User Manual

Stat-One and Stat-Two commands

Stat-One commands
DO1VSTATS
SETFREQ
SETSAMPLE
Stat-Two commands
DO2VSTATS
SETDEPEND
SETINDEP
Programming
The following commands are used for analysis of one-
variable and two-variable statistical data.
Calculates STATS using datasetname and stores the results in
the corresponding variables: N , Tot , Mean , PVar ,
SVar , PSDev, SSDev, Min , Q1, Median, Q3, and Max .
Datasetname can be H1, H2, ..., or H5. Datasetname must
define at least two data points.
DO1VSTATS datasetname
Defines datasetname frequency according to column or value.
Datasetname can be H1, H2,..., or H5, column can be C0–C9
and value can be any positive integer.
SETFREQ datasetname;column
or
SETFREQ definition;value
Defines datasetname sample according to column.
Datasetname can be H1–H5, and column can be CO–C9.
SETSAMPLE datasetname;column
Calculates STATS using datasetname and stores the results in
corresponding variables: MeanX, X, X2, MeanY, Y,
Y2, XY, Corr, PCov, SCov, and RELERR. Datasetname
can be SI, S2,..., or S5. Datasetname must define at least four
pairs of data points.
DO2VSTATS datasetname
Defines datasetname dependent column. Datasetname can be
S1, S2, ..., or S5 and column can be C0–C9.
SETDEPEND datasetname;column
Defines datasetname independent column. Datasetname can
be S1, S2,..., or S5 and column can be C0–C9.
SETINDEP datasetname;column
15-29