Installing Ddr2 Modules - MSI MS-7204 Instruction Manual

M S-7204 mBTX M ainboard
GREEN
DIMM1 (Ch A) DIMM2 (Ch B)
256MB~1GB 256MB~1GB
256MB~1GB
256MB~1GB
256MB~1GB 256MB~1GB
MSI Reminds You...
- Dual-channel DDR works ONLY in the 5 combinations listed in
the table shown in the previous page.
- Please select the identical memory modules to install on the dual
channel, and DO NOT install three memory modules on three
DIMMs, or it may cause some failure.
- Always insert the memory modules into the GREEN slots first, and
it is strongly recommended not to insert the memory modules into
the ORANGE slots while the GREEN slots are left empty.
- This mainboard DO NOT support the memory module installed
with more than 18 pieces of IC (integrated circuit).
- Due to the South Bridge resource deployment, the system density
will only be detected up to 3+GB (not full 4GB) when each DIMM is
installed with an 1GB memory module.

Installing DDR2 Modules

The DDR2 DIMM has only one notch on the center of module. The module will
1.
only fit in the right orientation.
Insert the DIMM memory module vertically into the DIMM slot. Then push it in
2.
until the golden finger on the memory module is deeply inserted in the socket.
The plastic clip at each side of the DIMM slot will automatically close.
3.
MSI Reminds You...
You can barely see the golden finger if the module is properly in-
serted in the socket.
2-8
ORANGE GREEN
DIMM3 (Ch A)
256MB~1GB
256MB~1GB
256MB~1GB
Volt
ORANGE
DIMM4 (Ch B) System Density
512MB~2GB
512MB~2GB
256MB~1GB 512MB~2GB
256MB~1GB 512MB~2GB
256MB~1GB 1GB~4GB
Notch