Keithley 2290-10 User Manual page 27

Section 4: Remote operation Model 2290-10 10 kV Power Supply User's Manual
To make a parallel connection to the instrument, stack the connectors. Each connector has two
screws to ensure that connections remain secure. The figure below shows a typical connection
diagram for a test system with multiple instrument .
To avoid possible mechanical damage, stack no more than three connectors on any one instrument.
To minimize interference caused by electromagnetic radiation, use only shielded GPIB cables.
Contact Keithley Instruments for shielded cables.
Figure 8: Model 2290-10 GPIB example connections
To connect the instrument to the GPIB:
1. Align the cable connector with the port on the rear panel. The location of the port is shown in the
following figure.
2. Attach the connector. Tighten the screws securely but do not overtighten them.
Figure 9: Model 2290-10 rear panel GPIB location
3. Connect any additional connectors from other instruments, as required for your application.
4. Ensure the other end of the cable is properly connected to the controller.
4-2 2290-10-900-01 Rev. A/December 2013