Bench Mounting; Save These Instructions; Additional Safety Rules; Functional Description - Makita LS1016 Instruction Manual

000030
30. Do not abuse cord. Never yank cord to
disconnect it from the receptacle. Keep cord
away from heat, oil, water and sharp objects.
31. NEVER stack workpieces on the table top to
speed cutting operations. Cut only one piece
at a time.
32. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.

SAVE THESE INSTRUCTIONS.

WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

ADDITIONAL SAFETY RULES

FOR THE LASER
CAUTION:
LASER RADIATION
•
BEAM.
AVOID EXPOSURE - LASER RADIATION IS
•
EMITTED FROM APERTURE.
USE OF CONTROLS OR ADJUSTMENTS OR
•
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE
RESULT IN
EXPOSURE.
DO NOT STARE INTO
SPECIFIED HEREIN
HAZARDOUS RADIATION
Complies with 21CFR
1040.10 and 1040.11
AVOID EXPOSURE-Laser
radiation is emitted from
this aperture
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
Maximum Output
<1mW,Wavelength:655nm
CLASS II LASER PRODUCT
009605
INSTALLATION

Bench mounting

When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. Release the stopper
pin by simultaneously applying a slight downward
pressure on the handle and pulling the stopper pin.
009483
WARNING:
USB094-1
Ensure that the tool will not move on the
•
supporting surface. Movement of the miter saw
on the supporting surface while cutting may result
in loss of control and serious personal injury.
This tool should be bolted with four bolts to a level and
stable surface using the bolt holes provided in the tool's
base. This will help prevent tipping and possible injury.
1
MAY
010593

FUNCTIONAL DESCRIPTION

WARNING:
Always be sure that the tool is switched off and
•
unplugged
function on the tool. Failure to switch off and
5
1. Stopper pin
1
1 1. Hex bolts
1
before adjusting or checking