Radio Shack Tone/Vibration Pager Owner's Manual page 7

17-6024.fm Page 7 Friday, August 6, 1999 11:00 AM
If you want the pager to have a new pager code,
enter the new 3-digit pager code and
.
PAGE
After you press
PAGE
digit code seven times and transmits the pager and
system codes to the pager. After the codes are trans-
mitted, the digits remain on the display until you:
• Turn off the transmitter.
• Press
CANCEL
• Send a message to the pager. The 4-digit code
flashes.
5. Once the pager code is stored, turn the pager off,
then on again before attempting to transmit a mes-
sage code.
Repeat Steps 1–5 to store or replace a code for each
pager used.
Notes:
• If the pager does not successfully store the pager
code, repeat the steps.
• You must reset all the pager's codes when you store
a new system code in your transmitter.
, the transmitter flashes the 4-
. - - - - appears.
, then press
0
7