Assembly Step - Vision TF40 Owner's Manual

assemBlY STEP 2

HARdWARE fOR STEP 2 :
all
SPRING ARC
BOLT (A)
models WASHER (B) WASHER (C)
20 mm
8.2 mm 8.4 mm
Qty: 6
Qty: 6 Qty: 4
T40 SHOWN
CONSOLE CABLES
RIGHT CONSOLE MAST
14
a open hardware for step 2.
B guide console cables from handlebars
FLAT
through and out of the tops of the console
WASHER (D)
8.2 mm
masts.
Qty: 2
C slide handlebars onto console masts.
noTe: do not pinch console cables while
attaching the handlebars.
RIGHT HANDLEBAR
d attach right handlebar to right console
mast using 1 flat washer (d), 1 spring
washer (b) and 1 bolt (a) from the inside and
2 arc washers (c), 2 spring washers (b)
and 2 bolts (a) from below.
noTe: do not tighten bolts until step 4 is complete.
BOLT (A)
Repeat on other side.
e
SPRING WASHER (B)
FLAT WASHER (D)
ARC WASHERS (C)
T40 assemBlY STEP 3
T40 HARdWARE fOR STEP 3 :
ARC
SPRING
WASHER (E)
WASHER (B)
8.4 mm
8.2 mm
Qty: 4
Qty: 4
BOLT (A)
20 mm
Qty: 2
T40 ONly
ARC WASHER (E)
SPRING WASHER (B)
HANDLEBAR BOLT (A)
SUPPORT BAR BOLT (F)
BASE FRAME
SPRING WASHER (B)
ARC WASHER (E)
noTe: This step is for T40 models only.
a open hardware for step 3.
BOLT (F)
95 mm
Qty: 2
attach the right support bar to the base
B
frame using 1 arc washer (e), 1 spring
washer (b) and 1 bolt (f).
noTe: do not tighten bolts until step 4 is complete.
attach the right support bar to the
C
handlebar using 1 arc washer (e), 1
spring washer (b) and 1 bolt (a).
Repeat on other side.
d
T40
onlY
15