Vision TF40 Owner's Manual page 10

T40 assemBlY STEP 4
HARdWARE fOR STEP 4 :
T40
ARC
SPRING
WASHER (E) BOLT (A)
WASHER (B)
onlY
20 mm
8.4 mm
8.2 mm
Qty: 6
Qty: 6
Qty: 6
T40 ONly
CONSOLE
MAST
MAST
COVERS
SCREWS (G)
BASE FRAME
18
noTe: This step is for T40 models only.
a open hardware for step 4.
SCREW (G)
12 mm
gently place console base on top of
B
Qty: 6
console masts.
noTe: Be careful not to pinch the console
cables while attaching the console base.
CONSOLE BASE
CONSOLE CABLES
Connect the console cables and tuck
BOLTS (A) C
them inside the console masts and slide
SPRING WASHERS (B)
console base into console masts.
ARC WASHERS (D)
Connect the console base to console
d
masts using 6 arc washers (e), 6
spring washers (b) and 6 bolts (a).
noTe: Tighten all bolts from sTePs 1–3.
attach mast covers to base frame
e
using 3 screws (g).
Repeat on other side.
F
Tf40 assemBlY STEP 4
HARdWARE fOR STEP 4 :
ARC
SPRING
WASHER (E) BOLT (A)
WASHER (B)
8.4 mm 20 mm
8.2 mm
Qty: 6
Qty: 6
Qty: 6
Tf40 ONly
BOLTS (A)
CONSOLE BASE
SPRING WASHERS (B)
ARC WASHERS (D)
CONSOLE CABLES
CONSOLE MAST
SCREWS (N)
BASE FRAME COVER
BASE FRAME
noTe: This step is for TF40 models only.
a open hardware for step 4.
SCREW (N)
12 mm
gently place console base on top of
B
Qty: 4
console masts.
noTe: Be careful not to pinch the console
cables while attaching the console base.
Connect the console cables and tuck
C
them inside the console masts and slide
console base into console masts.
Connect the console base to console
d
masts using 6 arc washers (e), 6
spring washers (b) and 6 bolts (a).
noTe: Tighten all bolts from sTePs 1–3.
attach the base frame covers to the
e
base frame using 4 screws (n).
TF40
onlY
19