T9600HRT and T9600HRT Comfort v5.6, v.5.9
Calibration Guide
CONFIRM CONFIGURATION
STEP 1
ENTER ENGINEERING MODE
• With the SAFETY KEY in place, hold the
buttons for 5 seconds. The profile window will read " " D D G G A A 3 3 J J " " and
DOWN"
the function window will read " " N N O O N N E E " " .
• You are now in ENGINEERING MODE.
STEP 2
CHECKING CONFIGURATION
• Press the
"ELEVATION UP"
window. Press
"SELECT"
" " 5 5 . . 6 6 " " or " " 5 5 . . 9 9 " " will appear in the elevation window and " " 1 1 0 0 " " will appear in
the speed window.
• To change configurations, press the
• Press the
button to update data.
"SELECT"
AUTO-CALIBRATION
STEP 3
ENTER ENGINEERING MODE
•
to " " P P 1 1 4 4 " " . The elevation window will read " " E E N N G G " " and the
"ELEVATION UP"
speed window will read " " O O U U T T " " . Press the
window will read " " E E N N G G 1 1 " " .
STEP 4
ENTER AUTO-CALIBRATIONS
• Press the
"ELEVATION UP"
• Press
.
"SELECT"
STEP 5
• Press
. The treadmill will calibrate itself. This will take about 3 to
"START"
5 minutes. When AUTO is complete, " " E E N N D D " " will appear in the window.
Wait 10 to 15 seconds and the treadmill will reset itself to " " P P 1 1 " " .
STEP 6
• Press
to test the treadmill.
"START"
Date of last revision: 12.05
"ELEVATION UP"
button until " " E E N N G G 1 1 " " appears in the function
. The function window will read " " 2 2 4 4 0 0 C C " "
or
"SPEED UP"
"SPEED DOWN"
"STOP"
or
to " " E E N N G G 4 4 " " .
"SPEED UP"
and
"SPEED
" " I I C C 0 0 0 0 " " .
or
button.
button. The function
1
ILLUSTRATIONS FOR DISPLAY PURPOSES ONLY
TREADMILL.CALIB.REV4