Vision TF40 Owner's Manual page 11

Tf20 assemBlY STEP 4
HARdWARE fOR STEP 4 :
TF20
ARC
SPRING
WASHER (E) BOLT (A)
WASHER (B)
onlY
20 mm
8.4 mm
8.2 mm
Qty: 6
Qty: 6
Qty: 6
Tf20 ONly
CONSOLE BASE
CONSOLE CABLES
CONSOLE MAST
BASE FRAME COVER
SCREWS (M)
BASE FRAME
20
noTe: This step is for TF20 models only.
a open hardware for step 4.
SCREW (M)
20 mm
gently place console base on top of
B
Qty: 4
console masts.
noTe: Be careful not to pinch the console
BOLTS (A) cables while attaching the console base.
SPRING WASHERS (B)
ARC WASHERS (D)
Connect the console cables and tuck
C
them inside the console masts and slide
console base into console masts.
Connect the console base to console
d
masts using 6 arc washers (e), 6
spring washers (b) and 6 bolts (a).
noTe: Tighten all bolts from sTePs 1–3.
attach base frame covers to base
e
frame using 4 screws (m).
assemBlY STEP 5
HARdWARE fOR STEP 5 :
FLAT
SPRING
WASHER (H) BOLT (I)
WASHER (J)
45 mm
8 mm
8 mm
Qty: 2
Qty: 4
Qty: 2
BOLT (I) BOLT (I)
FLAT WASHERS (H) FLAT WASHERS (H)
CONSOLE CONSOLE
CONSOLE REAR COVER CONSOLE REAR COVER
CONSOLE BASE CONSOLE BASE
PRE-INSTALLED PRE-INSTALLED
SCREWS SCREWS
CONSOLE CABLES CONSOLE CABLES
FLAT WASHERS (H) FLAT WASHERS (H)
SPRING WASHER (J) SPRING WASHER (J)
NUT (K) NUT (K)
T40 ONly:
SUPPORT BAR SUPPORT BAR
SUPPORT BAR CAP SUPPORT BAR CAP
a open hardware for step 5.
Remove 2 pre-installed screws to
B
NUT (K)
remove console rear cover from the
Qty: 2
console.
attach the console to the console base
C
using 2 bolts (i) and 2 flat washers
(h) from above and 2 flat washers (h) 2
spring washers (J) and 2 nuts (k) from
below.
noTe: Be careful not to pinch the console
cables while attaching the console.
Connect the console cables to the
d
console.
Re-attach the console rear cover to
e
the console using 2 pre-installed
screws.
T40 onlY: insert support bar caps into
F
bottom of support bars.
all
models
21