Tools Included; Parts Included - Vision TF40 Owner's Manual

PRE-assemBlY

TOOlS INClUdEd:

F 5 mm T-wrench
F 13 mm Hex wrench
UNPACkING
F 4 mm l-wrench
F 5 mm l-wrench
Place the treadmill carton on a level flat surface. it is recommended that you place a
all
F 6 mm T-wrench
protective covering on your floor. Take CauTion when handling and transporting this
models
F 8 mm T wrench
unit. once the banding straps have been removed, do not transport this unit unless it is
F screwdriver
fully assembled. unpack and assemble the unit where it will be used. never grab hold of
any portion of the incline frame and attempt to lift or move the treadmill. lift the treadmill

PARTS INClUdEd:

from the roller end caps area while a second person removes the parts packed under
the treadmill.
F 2 Console masts
F 2 Handlebars
F 2 support Bars
F 2 support Bar Caps (T40)
F 2 sets Base Frame Covers
F 1 Console Base
F 1 Console Base Cover
F 1 water Bottle Holder
F 1 accessory Holder
F 1 Hardware Kit
F 1 safety Key
F 1 Power Cord
NEEd HElP?
noTe: during each assembly step, ensure that all nuts and bolts are in place and
partially threaded in before completely tightening any one bolt.
if you have questions or if there
are any missing parts, contact
noTe: a light application of grease may aid in the installation of hardware. any grease,
your authorized Vision Fitness
such as lithium bike grease, is recommended.
retailer.
10
WARNING
do noT aTTemPT To liFT THe TReadmill! do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FailuRe To Follow THese insTRuCTions Could ResulT in inJuRY!
T40 assemBlY STEP 1
T40 HARdWARE fOR STEP 1 :
BOLT (A) SPRING WASHER (B) ARC WASHER (C)
20 mm 8.2 mm 8.4 mm
Qty: 6 Qty: 6 Qty: 6
T40 ONly
RIGHT CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
BASE FRAME
noTe: This step is for T40 models only.
a open hardware for step 1.
B attach lead wire to console cable and pull
lead wire through right console mast. after
pulling the lead wire through the mast, the top of
the console cable should be located at the top
of the mast. detach and discard lead wire.
noTe: do not pinch console cable when placing
n
the mast onto the base frame.
C attach console mast to base frame using 3
bolts (a), 3 spring washers (b) and 3 arc
washers (c).
noTe: do not tighten bolts until step 4 is complete.
d Repeat step C on other side.
T40
onlY
11