Sleep Mode - Pride Jazzy 1101 Owner's Manual

Sleep Mode

The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main
power if the joystick is not moved in any direction for a specific amount of time. This time factor is programmed into the
controller. The battery condition meter on the keypad indicates sleep mode by blinking once every five seconds. To restore
power and continue, push the on/off key twice.
Trouble Codes
The system status light is displayed within the on/off key. This light is lit if the system is turned on. It also flashes in groups
called flash codes, to indicate system faults. The table below identifies the individual fault codes. If your keypad displays
one of these codes, contact your authorized Pride Provider.
FLASH CODE
SEQUENCE
•—•—•—
••—••—••—
•••—•••—
••••—••••—
•••••—•••••—
••••••—••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
•••••••—•••••••—
NOTE: You must power the controller off and then on again to reset the controller, even if the source of the
fault is removed/corrected.
In the event of a fault, the system status light displays diagnostic indications. Faults are encoded as follows: one (for a low
battery voltage fault) to twelve (module mismatch) and are displayed by the light flashing the number of times prescribed
by the fault code. The flash sequence (one to twelve) is followed by a long off period (2 seconds). If more than one fault
exists, then the fault having the highest priority is indicated. The controller must be turned off and then on again even if the
source of the fault is removed. If you cannot resolve the problem, contact your authorized Pride Provider.
Jazzy 1101/1121
V I I . O P E R A T I O N
DIAGNOSIS
DX Module Fault
DX Accessory Fault
Left Motor (or Connection) Fault
Right Motor (or Connection) Fault
Left Park Brake Fault
Right Park Brake Fault
Low Battery Fault
Over Voltage Fault
CANL Fault
CANA Fault
Stall Timeout
Module Mismatch
www.pridemobility.com
SOLUTION
See your authorized Pride Provider.
See your authorized Pride Provider.
Check left motor wiring.
Check right motor wiring.
Check motor/brake wiring.
Check motor/brake wiring.
Check that the battery wiring is secure.
Check that the battery wiring is secure.
See your authorized Pride Provider.
See your authorized Pride Provider.
Turn unit on, then off.
See your authorized Pride Provider.
41