Comfort Adjustments - Pride Jazzy 1101 Owner's Manual

V . C O M F O R T

COMFORT ADJUSTMENTS

After becoming familiar with your Jazzy’s operation, you may find the need to make some adjustments to increase your
comfort, such as seat height and angle, armrest angle, footrest height and angle, and the controller’s position. If your Jazzy
is equipped with a Synergy Seat or Synergy Tru Balance, refer to the information provided in separate manuals. If your
Jazzy is equipped with a medium-back seat, a high-back seat, a reclining seat, or a power elevating seat, refer to the
following information.
WARNING! If your Jazzy was configured at your authorized Pride Provider, please consult your
healthcare professional before changing the seat position or making any other adjustment. Some
adjustments may degrade your Jazzy’s performance and safety by changing its center of gravity.
You may need the following to make comfort adjustments:
n metric/standard hex key set
n metric/standard socket set and ratchet
n adjustable wrench
Seat Height and Seat Angle Adjustment
There are four steel towers that connect the seat to the power base. See figure 6. You can change the seat height to one of
three positions in 1-in. increments by raising the seat towers. If you raise or lower only one set of seat towers (front or
rear), you can also change the seat base angle. If your Jazzy
is equipped with a power elevating seat, then you change
the seat height through the controller or a switch.
To change the seat height or seat angle:
1. Remove the ball detent pin from each of the four seat
towers.
2. Raise or lower each seat tower to the desired position.
To change the angle, set either the front or rear seat
towers higher or lower than the other.
3. Reinstall the ball detent pin into each seat tower.
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Remove the seat.
2. Remove both extrusions from the bottom of the seat. See figure 12.
3. Reposition the extrusions on a different set of mounting holes. See figure 15. You must move both extrusions the same
number of holes either forward or backward.
4. Fasten the extrusions back onto the bottom of the seat.
5. Reinstall the seat.
Reclining Seat
If your Jazzy is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever
is located on the right side of the seat base.
Jazzy 1101/1121
A D J U S T M E N T S
Figure 14. 1101/1121 Seat Height Adjustment
www.pridemobility.com
BALL DETENT PINS
STEEL TOWERS
19