Sleep Mode - Pride jazzy 1120 Owner's Manual

V I I . O P E R A T I O N
Speed and Actuator Adjustments
The Remote Plus joystick controller is equipped with a mode key and a speed indicator. See figure 39. The mode
key allows you to access different power chair functions. Activating the mode key allows you to adjust the
maximum power chair speed. To increase or decrease the overall speed, activate the mode key once. Pushing the
joystick to the right will increase the speed setting. Pushing the joystick to the left will decrease the speed setting.
The speed indicator LEDs will light up from left to right. When one LED is lit, the speed is in the slowest setting.
When all five LEDs are lit, the speed is in the fastest setting. After selecting your desired speed, activate the mode
key again to return to drive or simply activate the joystick in the forward or reverse direction and your Jazzy will
operate at the selected speed setting.
NOTE : We recommend that the first few times you operate your Jazzy 1120 you have your speed adjustment
mode on the slowest setting until you to become familiar with your new power chair.
If your Jazzy is equipped with power seat functions, you can access seat control by pressing the mode key twice.
Push the joystick to the right to toggle to your desired seat function. The LED will light in various positions
indicating which seat function is active. When the LED is lit in the appropriate section, push the joystick forward to
raise the actuator and push the joystick in reverse to lower the actuator. To return to drive, activate the mode key again.

SLEEP MODE

If your Jazzy 1120 is equipped with a Remote Plus controller, then you have a sleep mode feature. Sleep mode is
a built-in circuit that automatically shuts off the main power if the joystick is not moved in any direction for
approximately five minutes. The battery condition meter lights on the joystick indicate sleep mode by blinking once
every five seconds. To restore power and continue, push the on/off key twice.
THERMAL ROLLBACK
Jazzy 1120 controllers are equipped with a thermal rollback circuit. This circuit monitors the temperature of the
motors and the controller. In the event that the motors or the controller become excessively hot (above 50° C/122°
F), the controller reduces the motor voltage. For every degree above 50° C/122° F, the controller reduces the
voltage by 5 volts. This reduces your Jazzy’s speed and allows the electrical components to cool down. When the
temperature returns to a safe level, your Jazzy 1120 resumes its normal speed.
23
Jazzy 1120