Controller Position - Pride Jazzy 1101 Owner's Manual

V . C O M F O R T
BALL DETENT PIN
Figure 17. Footrest (Shroud removed)
Footrest Depth
To adjust the footrest depth:
1. Remove the nuts and bolts from the footrest bracket. See figure 17.
2. Move the footrest in or out to the desired depth.
3. Reinstall the nuts and bolts into the footrest bracket and tighten.
Footrest Angle
You can adjust the angle of the footrest with a hex key. See figure 18.
To adjust the footrest angle:
1. Turn the setscrew counterclockwise to raise the front of the footrest.
2. Turn the setscrew clockwise to lower the front of the footrest.

Controller Position

You can position the controller for either left-hand or right-hand use.
WARNING! Do not place the controller cable so that it
can be pinched in the seat frame or the power base
frame.
To change the controller position:
1. Unplug the controller connector and the charger inhibit connector
from the electronics tray. See figure 7.
2. Cut the wire tie that attaches the controller cable to the armrest.
3. Use a hex key to loosen the setscrew. See figure 19.
4. Slide the controller out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew.
8. Use a wire tie to secure the controller cable to the armrest.
9. Plug in the controller connector and the charger inhibit connectors to
the electronics tray.
Jazzy 1101/1121
FOOTREST BRACKET
NUTS AND BOLTS
www.pridemobility.com
A D J U S T M E N T S
Figure 18. Footrest Angle Adjustment
SETSCREW
Figure 19. Underside of Armrest
SETSCREW
21