Pride Jazzy 1101 Owner's Manual page 38

DYNAMIC DX CONTROLLER
The Dynamic DX electronic control system is a modular system. The electronics necessary to operate the power chair are
contained in several modules located on different parts of your power chair. The master remote is located typically on the
end of an armrest. The other components are located inside the power base. The Dynamic DX system consists of the
following components:
n Europa master remote (see figure 30)
n communications cable(s)
n power module
n motor wiring harnesses
n battery wiring harnesses
n actuator lighting module (for optional systems)
The controller supplied with your power chair has been pre-programmed to meet the needs of the end user. The program
is set using either a personal computer with software provided by the controller manufacturer or with a hand-held program-
mer, also provided by the controller manufacturer.
WARNING! The controller program can affect speed, acceleration, deceleration, and braking. But
if it is programmed incorrectly or outside of the safe limits as determined by your healthcare
professional, it can create a dangerous situation. Only the power chair manufacturer, an authorized
representative of the manufacturer, or a trained service technician should program the controller.
Europa Master Remote
The Europa master remote consists of the following:
1. joystick
2. keypad
3. controller communications connector
4. off-board charger/programming socket
Joystick
The joystick controls the direction and speed of the
power chair. When you move the joystick from the neu-
tral (center) position, the electromagnetic brake will re-
lease and allow the power chair to move. The farther
you push the joystick from its neutral position, the faster
your power chair will move. When you release the joy-
stick and allow it to return to the neutral position, you
engage the electromagnetic brake. This helps the power
chair decelerate and come to a complete stop.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the
joystick. Unless the joystick is damaged, this action should stop your power chair.
Out Of Neutral At Power Up
Your power chair joystick is equipped with Out Of Neutral At Power Up (OONAPU). If you power up the system and the
joystick is not in the neutral position, the system status light flashes rapidly for either as long as the joystick is out of the
neutral position or for five seconds. If this has happened and the all the lights on the battery condition meter are flashing, you
may have set flash code 1.
38
V I I . O P E R A T I O N
www.pridemobility.com
3
Figure 30. Europa Master Remote
1
2
4
Jazzy 1101/1121