Connecting The Input/ Output Terminals - Pioneer DJM-350 Operating Instructions Manual

Connecting the input/ output terminals

! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit's
input terminals and in the settings of the input selector switches.
Also refer to the operating instructions of the DJ software and audio interface.
Rear panel
R
R
AUDIO
OUT
CONTROL
USB
Example:
CDJ-350
DJ player
1 To use the fader start function, connect a control cord (page 9).
The fader start function can only be used when connected to a Pioneer DJ player.
2 A portable audio device can be connected using an RCA pin - mini-plug (Ø 3.5 mm) converter cable (page 10).
Front panel
Headphones
Headphones cord
6
En
To power outlet
Power cord (included)
L
L
Audio cable
Control cord 1
To ground
wire terminals
Analog player
Component, amplifier,
powered speaker, etc.
Audio cable
MASTER OUT
1 2
AC IN
L
L
R
R
Audio output section
Ground wire
Audio cable
To audio
output terminals
Portable
audio
device
To audio input terminals
Audio input section
SIGNAL
GND
CH-2 CH-1
PHONO CD PHONO CD
L L
L L
CONTROL CONTROL
R R
R R
Audio cable 2
Microphone
To audio
To microphone
output terminals
Microphone
AUX
L
MIC
L
R
R
cable