Connecting The Input/Output Terminals - Pioneer DJM-250 Operating Instructions Manual

Connecting the input/output terminals
When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit's
input terminals and in the settings of the input selector switches.
Also refer to the operating instructions of the DJ software and audio interface.
Rear panel, front panel
Audio input
section
Rear panel
ON
To power outlet
AC adapter
(included)
Audio output
section
Front panel
Headphones
Headphones
cord
1 To use the fader start function, connect a control cord (page 11).
The fader start function can only be used when connected to a Pioneer DJ player.
Cord hook
Loosen the cord hook's screw and pinch the AC adapters'
power cord under the hook.
Cord hook
Place the cord hook out of reach of children. If a child should
swallow it, contact a physician immediately.
6
En
Audio cable
R
R
AUDIO
OUT
CONTROL
USB
CH-2
SIGNAL
CD
PHONO / LINE PHONO / LINE
GND
OFF
L
L
CONTROL
LINE PHONO LINE PHONO
R
R
R L R
DC IN
R L
MASTER 2
R
R L
DC IN
MASTER 2
AC adapter' s power cord
Example:
CDJ-350
L
L
Control cord 1
CH-1 AUX
CD 3 2
L
L L
MIC
L L
R CONTROL
1
R R
R R
L
1GND
3 COLD
2 HOT
MASTER 1
Powered speaker, component,
amplifier, etc.
INPUT INPUT
1 1
2 2
EQ 3 EQ 3
POWER 4 POWER 4
To audio input terminals
Audio cable
Audio cable
DJ player Analog player
To ground wire
terminals
Ground wire
Audio cable
Microphone cable
To microphone
Audio cable
To audio output
terminals
Audio cable
To audio output
terminals
Audio cable
To audio output
terminals
To audio output
terminals
Microphone
Portable audio
device
Computer
synthesizer