Starting The Setup Wizard - Fortinet Switch 800F Installation Manual

NAT/Route mode installation

Starting the setup wizard

FortiGate-800/800F Installation Guide
Table 8: Setup wizard settings
Password
Internal Interface
External Interface
DHCP server
Internal servers
Antivirus
1 In the web-based manager, select Easy Setup Wizard.
Figure 9: Select the Easy Setup Wizard
2 Follow the instructions on the wizard pages and use the information that you gathered
in Table 6 on page 28
3 Select the Next button to step through the wizard pages.
4 Confirm the configuration settings, and then select Finish and Close.
Prepare an administrator password.
Use the information you gathered in
Use the information you gathered in
Starting IP:
Ending IP:
Netmask:
Default
Gateway:
DNS IP:
Your FortiGate firewall contains a DHCP server to automatically set up
the addresses of computers on your internal network
Web Server:
SMTP Server:
POP3 Server:
IMAP Server:
FTP Server:
If you provide access from the Internet to a web server, SMTP server,
POP3 server IMAP server, or FTP server installed on an internal
network, add the IP addresses of the servers here.
High Create a protection profile that enables virus
scanning, file blocking, and blocking of oversize
email for HTTP, FTP, IMAP, POP3, and SMTP. Add
this protection profile to a default firewall policy.
Medium Create a protection profile that enables virus
scanning, for HTTP, FTP, IMAP, POP3, and SMTP
(recommended). Add this protection profile to a
default firewall policy.
None Do not configure antivirus protection.
Select one of these security levels to protect your network from viruses.
and Table 8 on page 35
01-28006-0024-20041026
Starting the setup wizard
Table 6 on page
Table 6 on page
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
to fill in the wizard fields.
28.
28.
35