Getting Started - Vax Dual Power W86-DP-B Quick Manual

Getting started

PLEASE READ 'LEt'S tALk SAFEtY' At tHE BEGINNING BEFORE USE
Assembling your carpet washer
Stand base in Assemble the two lower handle screws and tighten
upright position and with a cross/flat head screwdriver.
lower top section to
connect onto base
Assemble the upper handle screw and tighten
with a cross/flat head screwdriver
Before you begin cleaning
• IMPORTANT: Carpets should be dry vacuumed thoroughly
• Test for colourfastness- Wet a white absorbent cloth with the
• Test your carpet/rugs/upholstery – Run the carpet washer over a
• Don't over saturate your carpets.
• When using the carpet washer, basic safety precautions should
• IMPORTANT: Only use Vax carpet solution. Using other solutions
Slide handle down
onto unit.
• IMPORTANT: The clean water tank should only be filled with
• CAUTION: This is a powerful carpet washer, before plugging in
Operating your carpet washer Operating your carpet washer Cleaning the shroud
Your dirty water tank is fitted with a float. When the dirty water tank is full or the floor head is not in contact with the
carpet the float will shut off the suction at the floor nozzle. You will be able to hear if this has happened as the motor
noise on the unit will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank is not
full then turn off your machine at the power switch and wait for the float to settle.
Xxxxxxxxxxxxx
Remove clean water tank
before washing
solution. In a small hidden area of your carpet/rugs/upholstery
gently rub with the dampened cloth. Wait ten minutes and check
for colour removal or bleed with white paper towel or cloth. If your
carpet has more than one colour, check all colours
small hidden area. If no pile distortion occurs continue cleaning
always be observed
may cause excess foaming and may invalidate your warranty
warm water (max 40°C). Filling the clean water tank with hot/
boiling water may damage your machine and invalidate your
warranty.
make sure all controls are turned off also hold carpet washer
firmly when staring and during use.
Using your machine
When cleaning an entire room,
move furniture out of the area
to be cleaned. If the furniture
is too heavy to move, place
aluminium foil or wax paper
under legs. This will prevent
wood finishes from staining
your carpet. Pin up furniture
skirts and curtains.
Unscrew the clean water Pour required dose of
tank cap from the top of carpet cleaning solution
the clean water tank. (approx.40ml per 1.0L of
water) and pour into tank.
TIP