Taking care of your machine
Cleaning the dirty water tank
IMPORTANT: Be sure to remove any debris that has accumulated in the screen above the float. If the screen
becomes clogged, this may reduce the performance of your cleaner.
IMPORTANT: For full suction it is important that the quick pour cap is securely in place. If misplaced, suction will be
severely affected.
Remove dirty water tank
Open quick spout pour cap and partially fill dirty water tank with
clean water and swirl around to loosen debris
To clean dirty water tank ducting, place dirty water tank
under a tap and dispense high pressure clean water into the
inlet port of the dirty water tank to loosen debris that has
accumulated
Storage
Empty and rinse out clean and dirty water tanks
and leave to air dry before replacing.
Do not leave solution stored in the tanks between uses.
Allow tank to dry
TIP
completely, replace quick
spout pour cap and insert
dirty water tank back
onto unit
During normal use of cleaning,
debris may accumulate inside
the dirty water tank. In order
to keep your unit functioning
properly and to prevent any
odours building up, it is best
to rinse out your dirty water
tank with fresh water after
each use.
Removing blockages from the brushbar
Threads caught in the
brushbar can be cut.
Replacing the belt or brushbars
WARNING: Do not open the motor cover.
Use a crosshead
Remove belt cover from unit.
screwdriver to remove
NOTE: Wheel is intended to
the seven screws.
be removed with belt cover.
To replace belt, slip
With the belt in place, pull
the brushbars through
and slide the brushbars
the belt. NOTE: Place
into the unit, making sure
belt on rounded areas
the brushbar end caps are
of brushbars without
in the correct position.
bristles.
Let's talk technical
WARNING
To reduce the risk of electric
shock, turn the machine off
and unplug from electrical
socket before performing
maintenance/
troubleshooting checks.
Pull both brushbars
Remove and dispose of
towards user to remove
old belt.
from unit.
Place new belt on motor shaft. Replace belt cover
and secure by replacing all screws.