Installing An Additional Fan; Washable Air Filters - Antec SONATA III User Manual

4.2 I A A
NSTALLING N DDITIONAL
There is one optional 120mm fan mount located at on the
side of the internal 3.5" drive bays. We recommend using
Antec 120mm speed control fans and setting the speed to
Low. These fans must be installed so that the air is blowing
into the case.
Front Fan – A front fan can be used to enhance graphics
card cooling. The fan should be installed to pull air into
the front of the case. To install the front fan, first remove
the side panel as described in section 2.1.
1. Find the fan mounting screw holes on the interior
of the case. They are located on the interior of the
internal 3.5" drive bay rails, below the cable
management compartment.
2. Secure your 120mm fan to the four screw holes
using the fan screws provided with the case.
4.3 W A F
ASHABLE IR ILTERS
Your case features a washable, removable front panel air
filter.
To remove the air filter:
1. Rest the case on its back or side.
2. Locate the two black air filter retention pinch tabs
at the front bottom of the case.
3. Pitch the outermost tabs together and pull the
filter from the case.
F
AN
14