Switching The Appliance On For The First Time; Installation, 5; Selecting The Language; Child Safety Lock - Hotpoint FDUD 43133 ULTIMA Instructions For Use Manual

• If fitting an under sink waste
disposal unit, cut out the membrane,
bung or blanking plug.
Ensure the drain hose is securely attached, to prevent it
coming away while the machine is in use and causing a flood.
Fit hose to waste securely using a "Jubilee" type clip.
*
Anti-flooding protection
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water supply
in the event of anomalies or leaks from inside the appliance.
Some models are also equipped with the supplementary safety
*
device New Acqua Stop , which guarantees anti-flooding
protection even in the event of a supply hose rupture
WARNING: HAZARDOUS VOLTAGE!
Under no circumstance should the water inlet hose be cut as it
contains live electrical parts.
The Company shall not be held responsible for any incidents
that occur if these regulations are not observed
Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack, if any.
Immediately before running the first wash cycle, completely fill
the salt dispenser with water and add only then approximately
see chapter Rinse-aid and refined salt
1 kg of salt (
may overflow: this is normal and is not a cause for concern.
Select the water hardness value (
refined salt
). After the salt has been poured into the machine,
*
the LOW SALT indicator light
If the salt dispenser is not filled, the water softener and the
heating element may get damaged as a result.
.
). The water
see chapter Rinse-aid and
switches off.
The control panel features a "Touch Control" system
press the symbols lightly with your fingertips to activate
the command.
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.

Switching the appliance on for the first time

Selecting the language

Switch on the machine using the ON/OFF button and select the
desired language using the buttons next to the grey arrows (the
default language is English.)
Press the OK button to confirm the selection.
Press the ESC button to exit or wait a few seconds.
SETTINGS button
This button makes it possible to select:
logo display, volume of buzzer/set of tones, language
selection, rinse aid adjustment, water hardness adjustment,
control panel lock.

Child safety lock

The control panel lock can be activated when the
dishwasher is switched on or when a cycle is in progress using
the "Lock" button. Press again to deactivate the function.
Use the SETTINGS button to access the menu. The control
panel lock can be activated automatically after 10/30 seconds
from the cycle start.
*
;
GB
(depending on the
.
7