Controlling; Modules; O Set The; Leep - X10 SUPERREMOTE UR19A Owner's Manual

C
ONTROLLING
X-10 M
If you have purchased and installed a
Transceiver Module, you can control it
and other X-10 modules as follows:
1. Press and release
the X-10 button.
2. Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do
not need to enter
'0' first for a single
digit number.)
3. Press the appro-
priate button for the
function you require
(see below).
X-10 FUNCTIONS:
On:
Off:
Bright:
Dim:
All Lamps On:
All Modules Off:
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
T X-10 S

O SET THE

The X-10 Sleep Timer switches off the
chosen modules after the preset time.
1. Press and release
the X-10 button.
2. Press and hold
TIMER until the LED
indicator lights
steadily. Release
TIMER button.
ODULES
CHANNEL +
CHANNEL –
VOLUME +
VOLUME –
POWER
MUTE
T

LEEP

IMER
26
3. Use the number
buttons to enter the
module Unit Code
for the module to
be turned off.
4. Press the desired
function button (e.g.
CHANNEL - to turn
the module off after
the preset time).
5. Using the number
buttons enter the
sleep time required
(1 to 99 mins).
6. Press ENTER to
confirm the setting.
C
HANGING THE
C :
ODE
The SuperRemote defaults to House Code
A, and in most cases you will not need to
change this unless you are experiencing
interference from a neighboring X-10
system.
1. Press and release
the X-10 button.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Use the number
buttons to enter the
number equivalent
to the chosen
House Code
(1=A, 2=B ..16=P).
X-10 H
OUSE
27