X-Rite SpectraLight III Operation Manual page 5

misjudgments, the background on which the sample is placed and the surrounding area of view should be neutral in
color and have a low gloss. It is typically recommended that Munsell N7/ is used.
•
White backgrounds are recommended when evaluating low gloss or light color samples, gray backgrounds are
recommended when evaluating medium gloss of intermediate color samples, and matte or flat black backgrounds are
recommended when evaluating high gloss or dark color samples.
Viewing Booth Installation
Note: To ensure adequate support and space for the unit, see "SPECIFICATIONS" on page1.
1. Move the viewing booth shipping container to the general area that the booth is to be used. Be sure to allow for
sufficient room for assembly (approximately 10 ft x 10 ft area is recommended).
2. Carefully unpack and remove the viewing booth components from the shipping containers. Carefully examine each
shipping container for contents before discarding it.
3. Place the Bottom Panel (#1) on a clean, smooth surface. See Figure 1.
4. Position the Rear Panel (#2) bottom notches into the Bottom Panel (#1) rear slots. Fasten the Rear Panel to the
Bottom Panel by securing it with two thumbscrews as shown in Figure 2.
(3)
Left
Side Panel
Front Panel
Avoid scratching the surface of any of the items in the following steps.
Slot
(2)
Rear Panel
(5)
(1)
Bottom Panel
FRONT
CAUTION
Figure 1. Bottom Panel
Page 5
(4)
Right
Side Panel