Safety Instructions - X-Rite SpectraLight III Operation Manual

•
PLEASE READ AND FOLLOW INSTRUCTIONS—Read and follow all instructions before you attempt to
assemble, install or operate the unit.
•
RETAIN THIS MANUAL FOR FUTURE REFERENCE—Once you have read this manual, keep it handy for
others to read or refer to when they need to operate the unit.
•
OBEY WARNINGS—Please comply with all warnings and safeguards that we provide in this manual. They
have been written to keep you and your unit safe. If the unit is used in a manner not specified in this manual,
the protection provided by the unit may be impaired.
•
USE ONLY A PROPER POWER SOURCE—Use the proper power source for this unit. Consult the power
label on the back of the unit for this information. Operation with a power source not specified on the power
label may result in inaccurate lighting conditions, damage to the equipment, and possible personal injury.
•
DO NOT BLOCK VENTS— Light sources contribute heat to the area of operation. SpectraLight III thermal
contribution is 5460 BTU maximum that is dissipated through the vents in the top panel. Blocking of the vent
could result in overheating, mechanical failure, and a fire hazard if flammables or combustibles are present.
•
PROTECT FROM WATER AND MOISTURE—Do not install overhead luminaires under a sprinkler system.
Maintain electrical safety when you use this unit. Do not use it in an area where there is possible hazard of
electric shock from spilled water or other liquids or uncontrolled moisture.
•
CLEAN PROPERLY—You can wipe the unit with a clean, white lint-free cloth. Do not apply liquid cleaners or
agents containing wax, since these can yellow and change reflectance and gloss properties. Clean outer
surfaces with a dampened cloth containing a mild soap.
•
CAREFULLY HANDLE THE LAMPS AND DAYLIGHT FILTERS—Allow the lamps and daylight filters to cool
before handling them. Always use lens paper or an equivalent to handle any of the replacement tungsten
lamps. Skin oils interfere with lamp performance.
•
UV-A EMISSIONS—A low level UV radiation is emitted when the UV feature is activated. Avoid direct
exposure of 15 minutes or more under UV radiation. Protective measures are required for prolonged
exposure.
X-Rite, Incorporated ("X-Rite") warrants each instrument manufactured to be free of defects in material and workmanship
for a period of 12 months, unless different local regulations apply. This warranty shall be fulfilled by the repair or
replacement, at the option of X-Rite, of any part or parts, free of charge including labor, F.O.B. its factory or authorized
service center.
This warranty shall be voided by any repair, alteration, or modification, by persons other than employees of X-Rite, or
those expressly authorized by X-Rite to perform repairs, and by any abuse, misuse, or neglect of the product, or by use
not in accordance with X-Rite's published instructions.
X-Rite reserves the right to make changes in design and /or improvements to its products without any obligation to include
these changes in any products previously manufactured. Correction of defects by repair or replacement shall constitute
fulfillment of all warranty obligations on the part of X-Rite.
THIS WARRANTY IS EXPLICITLY IN LIEU OF ANY OTHER EXPRESSED OR IMPLIED WARRANTIES, INCLUDING
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. THIS
WARRANTY OBLIGATION IS LIMITED TO REPAIR OR REPLACEMENT OF THE UNIT RETURNED TO X-RITE OR AN
AUTHORIZED SERVICE CENTER FOR THAT PURPOSE.
This agreement shall be interpreted in accordance with the laws of the State of Michigan and jurisdiction and venue shall
lie with the courts of Michigan as selected by X-Rite, Incorporated.

SAFETY INSTRUCTIONS

WARRANTY INFORMATION
Page 3