Applications - Accton Technology CheetahSwitch Workgroup-2027 Quick Installation Manual

ACCTON CheetahSwitch Workgroup-2027 V1.00 05-04-97
Port Configuration ...
Password Configuration ...
Restart System
Factory Reset
Exit
Configure port setting.
<Enter> to confirm.
Note:
Configuring the Ports
ACCTON CheetahSwitch Workgroup-2027 V1.00 05-04-97
Port Configuration
====================================
Back to Previous Menu
Port Enabled
=============================================
1 YES
2 YES
3 YES
4 YES
5 YES
6 YES
7 YES
8 YES
9 YES
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Field Description
Enabled Allows you to disable a port due to abnormal behavior (e.g., excessive collisions),
and then re-enable it after the problem has been resolved. You may also disable a
port for security reasons.
Duplex Ports 1 - 25 support full duplex and half duplex. (The default is Half.)
Ports 26 - 27 support auto-negotiation, full and half duplex. (The default is Auto.)
Fwd Mode Sets the forwarding method to cut-through (CT), or store and forward (St&Fwd).
Setting a Password
Restarting the System
8
CheetahSwitch Workgroup-2027
Main Menu
---------
Duplex Fwd Mode
Half St&Fwd
Half St&Fwd
Half St&Fwd
Half St&Fwd
Half St&Fwd
Half St&Fwd
Half St&Fwd
Half St&Fwd
Half St&Fwd
Next Page
Factory Reset
Logging Off the System

Applications

Bridging Functions
Switching Functions
Flexible Configuration
Quick Installation Guide
9