Honeywell DCS19W Installation And User Manual page 42

Diagnostic Indicator Display
Error
Code
LASER #2 (RIGHT HORIZONTAL) HIGH CURRENT WARNING – The laser in the vertical
25 scanning subsystem is drawing excessive current. This could be a warning for a future total
failure. Have the unit checked at an authorized service center when convenient.
LASER #3 (LEFT HORIZONTAL) HIGH CURRENT WARNING – The laser in the vertical
26 scanning subsystem is drawing excessive current. This could be a warning for a future total
failure. Have the unit checked at an authorized service center when convenient.
LASER #1 (VERTICAL) UDNERCURRENT WARNING – The laser in the vertical scanning
subsystem is drawing too little current. The laser is probably not on. This could be the result of
27
a loss of the required set point in memory. Have the unit checked at an authorized service
center.
LASER #2 (RIGHT HORIZONTAL) UNDERCURRENT WARNING – The laser in the right
horizontal scanning subsystem is drawing too little current. The laser is probably not on. This
28
could be the result of a loss of the required set point in memory. Have the unit checked at an
authorized service center.
LASER #3 (LEFT HORIZONTAL) UNDERCURRENT WARNING – The laser in the left vertical
scanning subsystem is drawing too little current. The laser is probably not on. This could be the
29
result of a loss of the required set point in memory. Have the unit checked at an authorized
service center.
MOTOR #1 (VERTICAL) ERROR – The motor in the vertical scanning subsystem denotes a
failure. The scanner will try three times to correct the motor operation. If the motor error
31
persists, the vertical scanning subsystem will be shut down and this error code will remain on the
Diagnostic Indicators.
MOTOR #2 (HORIZONTAL) ERROR – The motor in the horizontal scanning subsystem denotes
a failure. The scanner will try three times to correct the motor operation. If the motor error
32
persists, the horizontal scanning subsystem will be shut down and this error code will remain on
the Diagnostic Indicators.
MOTOR #1 (VERTICAL) SPEED ERROR – The motor in the vertical section cannot be speed
34
controlled as desired. Have the unit checked at an authorized service center.
MOTOR #2 (HORIZONTAL) SPEED ERROR – The motor in the horizontal section cannot be
35
speed controlled as desired. Have the unit checked at an authorized service center.
38
Description