La-Z-Boy Spas Dream Owner's Manual page 23

4. Press
the icon swirl faster.
Note: Repeatedly pressing the button raises the speed each time (40%, 60%, 100%,
and OFF*).
5. If the water is running smoothly through the lines, open the air control valve; you
should see an increase in jet pressure. Check and adjust the water/airflow of every
jet if necessary. Do this for all pumps to ensure proper operation. Each jet** in your
spa / hot tub can be adjusted for directional flow. Turn the outer jet dial fully
counterclockwise to permit water flow from a jet and allow the AquaFlex Massage
control intensity. Pivot the angle of a jet to achieve an optimal massage. Adding an
air mixture intensifies the level of your massage. Turn the air control valve
counterclockwise to increase the air mixture and clockwise to turn it off.
Note: To minimize heat loss, close the air control valve when your spa / hot tub is not
in use.
6. Continue pressing
Note: When programmed for continuous filtration and when temperature limits allow,
Pump 1 and the ozone generator run continuously to help keep your water clean (see
page 29).
7. Press the Pump 2 button
(fixed-speed) turn on, see water circulating in the spa / hot tub, and see the icon
swirl on the display. If Pump 2 has not primed after 3 minutes repeat same priming
procedure of step 3 above for Pump 1. Check and adjust the water and airflow of
every jet from Pump 2 if necessary.
8. Press
and see the icon swirl faster.
9. Press
Pump 2 off
* If the spa is in filtration mode, the pump slows to 10% and does not turn OFF.
**The 3" spinner jets and the constant filtration jets are not adjustable.
For HELP, call La-Z-Boy
again. You should hear the first pump turn on a higher speed and
until Pump 1 slows.
again. You should hear the second pump turn on a higher speed
a third time to turn off Pump 2. A built-in timer automatically turns
after 20 minutes,
Spas at 1.800.465.2933.
®
(if equipped). You should hear the second pump
unless
23
you turn it off first.