Operational Checks - La-Z-Boy Spas Dream Owner's Manual

Operational Checks

CAUTION: Do not turn on any pump until your spa is properly filled with
By now you have rechecked your spa / hot tub mechanical connections and filled it
with water to about 1" above all jets by adding cold tap water (if equipped) through the
pre-filter (if equipped). Turn on power to the spa / hot tub at the main breaker panel
and test the operation of the electrical system. If you encounter a problem, please
reference the troubleshooting guide on page 52.
1. Turn on the breaker and test the operation of the Ground-Fault Circuit Interrupter
(GFCI) breaker by pushing the small button. This should automatically trip the spa /
hot tub circuit breaker. Only if pushing this button successfully trips this circuit
breaker should you reset this breaker and proceed to the next step.
DANGER: If this breaker does not trip, immediately call your electrician.
2. Go to the topside control panel and look at
the display. The system goes through a brief
startup sequence after which Pump 1 starts
in filtration mode and the panel displays the
current water temperature.
3. Press the Pump 1 button
pump turn on a higher speed, see water circulating in the spa, see the icon swirl on
the display, and see CO in the Personal AquaFlex Massage Control (see page 41).
CAUTION: If water does not flow from the jets after 2 minutes, turn pow-
For HELP, call La-Z-Boy
water. Running any pump without water in your spa can cause
IMMEDIATE damage, which is not covered by the guarantee!
Do not use your spa / hot tub!
. You should hear the first AquaFlex Massage
er off at the main panel and bleed air from the system (see
page 51). Turn power on again. Sometimes momentarily turn-
ing a pump off/on will prime it. Only do this four times
Spas at 1.800.465.2933.
®
Figure 9 – Topside Control Panel
22
®
.