Connecting Camera Power - Lorex LW1012 Instruction Manual

4. Replace the camera in the desired mounting position. Tighten the side screw to secure the camera to
the Stand. Adjust the angle of the camera until the desired view is set.

Connecting Camera Power

The Camera can be powered either by using the provided Power Adaptor, or using a 9v battery and the
Battery Adaptor Cable:
•
POWER ADAPTOR: Connect the Power Adaptor to the Camera.
•
BATTERY: Connect the battery adaptor cable. Connect a 9 Volt Battery to the adaptor cable
(NOTE: The new 9V Battery should last for approximately 4 hours without the IR LEDs in use).
NOTE: Wireless cameras require a power source (either an electrical outlet or battery power) to
operate. If you plan to permanently mount the camera in a location, it is recommended to use the
included Camera Power adaptor to prevent interruptions in the image, as the battery adaptor is
intended as a temporary power solution.
Power Adaptor:
Connect the Power
Adaptor to the Female
Barrel Power
termination on the
camera.
Battery: Connect the
Camera Battery Adaptor
cable to the Female
Barrel Power termination
on the camera. Connect
a battery to the cable.
11