Installing The Camera - Lorex LW1012 Instruction Manual

Camera Installation

Installing the Camera:

1. Carefully unpack the Camera.
2. Decide whether the camera will be permanently wall mounted or sit on a
tabletop:
•
If you decide to place the camera on a tabletop or other flat surface, the
camera can easily be moved to different locations as desired. It is
strongly recommended that the camera be affixed to the table top
surface to prevent damage to the camera in case of tabletop surface
movement or improper handling.
•
If you decide to permanently mount the camera to a wall, make sure to
select a location close to a power outlet.
NOTE: Wireless cameras require a power source (either an electrical outlet
or battery power) to operate. If you plan to permanently mount the camera
in a location, it is recommended to use the included Camera Power
adaptor to prevent interruptions in the image, as the battery adaptor is
intended as a temporary power solution.
Wall Mounting Instructions
To mount the camera to a wall:
1. Loosen the screw located on the side
of the camera base using a slot head
screwdriver.
2. Pull the camera free from the Stand.
3. Mount the stand to the wall:
•
Mark the position of the two screw holes
on the wall.
•
Drill holes and insert the drywall plugs as
needed.
•
Position the power cable through either
slot on the top or bottom of the stand as
desired.
•
Firmly attach the stand to the wall using
the provided screws.
10
Table Top Mount:
The Camera can be
placed on any flat
surface.
1
2
3