Connecting Camera Power - Lorex LW1000P Series Instruction Manual

Optimizing the Wireless Signal
In order to provide the best possible video transmission, you will need to
adjust the antenna of the camera and receiver as follows.
1. Position the receiver's patch antenna to face the general direction of the
camera
2. Position the camera's patch antenna to face the general direction of the
receiver
3. Adjust the direction as necessary while observing the screen.

Connecting Camera Power

The Camera can be powered either by using the provided Power Adaptor, or using a 9v battery (not
included) and the Battery Adaptor Cable:
POWER ADAPTOR: Connect the Power Adaptor to the Camera.
BATTERY: Connect the battery adaptor cable to the camera. Connect a 9 Volt Battery to the
adaptor cable (NOTE: A new 9V Battery should last for approximately 4 hours without the IR
LEDs in use).
NOTE: Wireless cameras require a power source (either an electrical outlet or battery power) to
operate. If you plan to permanently mount the camera in a location, it is recommended to use the
included Camera Power adaptor to prevent interruptions in the image, as the battery adaptor is
intended as a temporary power solution.
Power Adaptor:
Connect the Power
Adaptor to the Female
Barrel Power
termination on the
camera.
12
Connecting Camera Power
Battery: Connect the
Camera Battery Adaptor
cable to the Female
Barrel Power termination
on the camera. Connect
a battery to the
connector.
Patch
Antenna
Hinges