Advertisement
INSTALLATION
Ensure electrical power is not connected to the dome camera and PC system
during installation.
DIAGRAM SHOWING TYPICAL SET-UP
65ft
6Pin Din
Cable
Pan/Tilt
Dome Camera
Important Note:
For the P/T/Z Camera Model setting in the Camera menu of Setup in the VistaPro4, the
DCP1000 is the "DYNACOLOR" camera in the drop down menu.
STEP BY STEP SETUP INSTRUCTIONS
Step 1: Mounting the Camera
Separate the back-plate from the base of the camera by gently twisting the base while
securing the back plate.
Attach the camera back plate on the ceiling using the Ø3 X 20 screws (supplied)
Secure the camera to the ceiling by gently twisting the base of the camera onto the
ceiling mounted back plate
Connect the 65' Camera DIN cable to the female DIN input found on the Camera.
Connect the other end of the cable to the Interface box.
Do not hold clear bubble or the swivel when attaching the camera to
the back plate.
7ft
RS485
Cable
PT
Interface
3
RS-232C to RS-485
CONVERTER
RS-485(+)
RS-485(-)
DC12V
VIDEO
(VistaPro 4 Main
Board)
RS-232C
(to PC COM Port)
Advertisement
