Subscribe to Our Youtube Channel
Related Manuals for Lorex DCP1000
Summary of Contents for Lorex DCP1000
- Page 1 AUTO PAN TILT COLOR DOME CAMERA FOR USE WITH VISTAPRO4 DIGITAL MONITORING SYSTEM DCP1000 DYNACOLOR...
- Page 2 Slow speed Pan/Tilt operation (15° per second) at 355° pan and 80° tilt range 3.6mm lens, 1Lux (F 2.0) CONTENTS This Package Contains: 65 ft DIN extension DCP1000 Color Auto Pan Pan Tilt Controller and 7 ft RS485 Tilt Color Dome Camera Interface Module...
- Page 3 Camera ID selection 6 Pin DIP switch TO CAMERA - transmits the Pan/Tilt control signals from the VistaPro 4 to the DCP1000 Dome Camera - receives the video signal from the DCP1000 Camera to the VistaPro 4. TO DVR - receives the RS-485 signal from the PC’s Comm port (via the ACC-RS232 connector) - transmits the video signal that comes from Pan/Tilt Dome Camera to DVR.
- Page 4 Board) Important Note: For the P/T/Z Camera Model setting in the Camera menu of Setup in the VistaPro4, the DCP1000 is the “DYNACOLOR” camera in the drop down menu. STEP BY STEP SETUP INSTRUCTIONS Step 1: Mounting the Camera Separate the back-plate from the base of the camera by gently twisting the base while securing the back plate.
- Page 5 Step 3: Setting the Camera Address The Dip Switch setting of the camera connected to the PT Interface must correspond to the RCA Camera Input of the VistaPro 4 TECHNICAL SPECS: DCP1000 Pan/Tilt Dome Camera Image sensor 1/4" Color CCD...
Need help?
Do you have a question about the DCP1000 and is the answer not in the manual?
Questions and answers