Advertisement
Step 2: Connecting the Camera to the VistaPro4 Digital Video Capture Card
At the location of the PC, plug the other end of the 65' Camera DIN cable into the DIN
port labeled "To Camera" found on the PT interface module.
Using the 7' RS-485 Connection Cable, connect the end terminated with the DIN plug to
the port labeled "To DVR" (next to the DIP switches) on the PT Interface module.
On the other end of the RS-485 Connection Cable, screw the single orange wire into the
"TX +" terminal of the ACC-RS232, and the green wire to the "TX –" terminal.
Plug the RCA jack (from the RS-485 Connection cable" into the desired Camera Input
found on the VistaPro4 card.
Connect the ACC-RS232 connector into an available DB9 Comm Port.
Step 3: Setting the Camera Address
The Dip Switch setting of the camera connected to the PT Interface must correspond to
the RCA Camera Input of the VistaPro 4
TECHNICAL SPECS: DCP1000 Pan/Tilt Dome Camera
Image sensor
Active pixels
Image sensor area
Resolution
Min. illumination
Video output
Electronic iris
Lens
Synchronization
Signal format
System connection
Power source
Power consumption
Operating temperature
Dimension
Weight
Pan/Tilt speed
Pan travel
Tilt travel
1/4" Color CCD
512(H) X 492(V)
4.8(H) X 3.7(V) mm
> 330 TV lines
1 Lux (F2.0)
1.0V p-p (75 ohms)
1/60 ~ 1/100,000 sec
3.6mm
Internal
525 lines, 2:1 interlace
6 Pin Mini DIN jack
DC12V (from interface or controller)
MAX. 2.4W
-10°C ~ +50°C
126 X 107 mm
1Kg
15° per second
355°
80°
4
Advertisement
