Brother MFC-J6510DW User Manual page 90

d
Turn the green release lever on the
orange protective packing (1) clockwise
until it clicks to release the vacuum seal.
Then remove the orange protective
packing as shown.
e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Gently push the back of the ink cartridge
marked "PUSH" until it clicks, and then
close the ink cartridge cover.
1
g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cartridge, for
example Black, the LCD may ask you to
verify that it was a brand new one (for
example, Did You Change
1
For each new cartridge you installed,
press Yes to automatically reset the ink
dot counter for that colour. If the ink
cartridge you installed is not a brand new
one, be sure to press No.
• If the LCD shows No Ink Cartridge or
Cannot Detect after you install the ink
cartridges, check that the ink cartridges
are installed correctly.
If ink gets in your eyes, wash it out with
water at once and call a doctor if you are
concerned.
Routine maintenance
CAUTION
Black).
A
67