Remote Control Battery Installation; Remote Control Receivers And Operating Range; Wired Remote Control Transmitter - Eiki LC-WXL200A Owner's Manual

Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Remote Control Receivers and Operating Range

Point the remote control toward the projector (to Infrared Remote
Receivers) when pressing the buttons. Maximum operating range
for the remote control is about 16.4' (5 m) and 60 degrees in front,
back and top of the projector.
Infrared Remote Receivers are provided in front, back and top of
the projector. You can conveniently use all of the receivers (pp. 10,
11, 59).
Note:

When hanging the projector from the ceiling, select the Infrared
Remote Receiver which is located farther away from the fluorescent
light (p.59).
The remote control can be used as a wired remote control. Wired
remote control helps you use the remote control outside of the
operating range (16.4'/ 5 m). Connect the remote control and the
projector with the remote control cable (supplied). Connected with
the remote control cable, the remote control does not emit wireless
signal.

Remote Control Battery Installation

Install new batteries into
2
the compartment.

Wired Remote Control Transmitter

Part Names and Functions
Replace the
3
compartment lid.
Two AAA size
batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins
in the compartment.
16.4'
(5 m)
16.4'
(5 m)
15