Dixon 3000 SERIES Operator's Manual page 15

CHASSIS:
BODY:
MOWER DECKS:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
SPECIFICATIONS
Model ZTR 3014
Twin 12 gauge side frames and 7 gauge transmission
and engine base plate.
All body parts are made of rotational molded polyethyl-
ene. Front body contains access panel for battery
service. Seat tilts forward to allow transmission service.
36" Deck: 11 GA Laser Cut Fabricated - 36" Cut Width
42" Deck: 13 GA Stamped Steel Construction - 42" Cut
Width Cut height approx. 1" to 4" via 7 position lift handle.
Electric clutch.
Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
13.5 HP Briggs & Stratton Intek,4-Cycle, Single Cylinder,
Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft,
Cast Iron Cylinder, AVS (Anti Vibration System), Pressure
Lube & Filter
Electric by key switch operation with safety interlocks on
parking brake and blade drive.
Front
Rear
Front
Rear
Fuel
Engine
Width
Height
Length
Weight
11 X 4.00 -5 ribbed tread.
18 X 8.50-8 Multi Trac tread.
16-21 PSI
8-14 PSI
2.0 gallons total.
1.25 quarts oil.
43.0" outside rear wheel measurement.
36.0" to top edge of seat.
65.5" hitch tab to front bumper.
36" Deck: 500 lbs. 42" Deck: 520 lbs.
15