Mezzanine Card Option - HP ProLiant BL280c G6 User Manual

Remove the access panel (on page 13).
3.
If installed, disconnect the hard drive power and data cables from the system board
4.
connector
Remove the air baffle.
5.
Configure the air baffle
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
Install the air baffle (on page 13).
9.
If removed, connect the hard drive power and data cables to the system board
10.
identification" on page 9).
Install the access panel (on page 13).
11.
If you are installing DIMMs in mirrored or lock-step configuration, configure this mode in RBSU
ROM-Based Setup

Mezzanine card option

Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The card
type determines where it can be installed in the server blade.
•
Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
•
Install Type II mezzanine cards only on mezzanine 2 connector.
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page 8).
For mezzanine card mapping, see the HP ProLiant BL280c G6 Server Blade Installation Instructions or see
"Interconnect bay numbering and device mapping (on page 16)."
Because mezzanine cards are supported on multiple server blade models, the mezzanine card may have
captive screws that are not required to secure it to the server blade. When installing a mezzanine card in this
server blade, only two captive screws are required.
identification" on page 9).
("Configuring the air baffle for DIMM
Utility" on page 58).
("Hard drive
installation" on page 33).
("Hard drive connector
Hardware options installation 36
("HP