Appendix 10: Connecting Ptz Cameras - Lorex L19WD800 Series Instruction Manual

Appendix 10: Connecting PTZ Cameras

You can connect PTZ cameras (not included) to the PTZ Control Block on the rear panel of the
system. You can configure the PTZ Cameras in the Camera Menu of the system. Additional
PTZ Cameras are available at
Installing a PTZ Camera:
1. Connect the Transmit Cable to the TX port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the RX port of the PTZ block on the rear panel.
3. Connect the PTZ camera to a BNC Channel.
4. From the System Main Menu, click
Note: The PTZ camera settings depend on the Type of Camera - refer to the specific
Camera Manual for your brand and model of PTZ Camera.
1 2 3 4 G 5
www.lorexcctv.com
ETHERNET PS/2
ALARM IN RELAY PTZ RS-232
6 7 8 G 9 10 11 12 G 13 14 15 16 G NO COM NC D+ D- G TX RX
PTZ CAMERA
(Not Included)
and then click PTZ to configure the camera.
CH1 CH2 CH3 CH4
CH9 CH10 CH11 CH12
AU1 AU2 AU3
CH1-4 CH5-8 CH9-12 CH13-16
L19WD Series
POWER
DC12V
CH5 CH6 CH7 CH8
CH13 CH14 CH15 CH16
AU4 AU OUT MONITOR SPOT
73