Life Fitness Lifecycle C3 Assembly Instructions Manual page 6

1. Before proceeding, familiarize yourself with the parts of the Lifecycle
exercise bike and make sure that you have received all the items
described in the Parts List.
2. Remove the STABILIZER BAR (#5) from the carton base. Remove the
two BOLTS (#1) from the bottom of the SHIPPING STABILIZER (A),
save the BOLTS and store the SHIPPING STABILIZER with the other
shipping containers.
3. Use the same two BOLTS (#1) that held the SHIPPING STABILIZER
(A) in place to attach the STABILIZER BAR (#5) as shown. Make
certain that the BOLTS are tight and the STABILIZER BAR is flush
against the frame.
4. Unfold the CONSOLE WIRE HARNESS (B) from the POST extending
from the FRAME.
NOTE: THE COLLAR (#3) SHOULD ALREADY BE IN PLACE
INSTALLED ON THE HANDLEBAR ASSEMBLY (#4). IF NOT,
INSTALL BEFORE PROCEEDING.
5. Place the HANDLEBAR ASSEMBLY (#4) on the floor in front of the
FRAME with the two CONNECTORS (8P) next to each other. Align
the two CONNECTORS and push them together until they firmly snap
into place.
6. Position the HANDLEBAR ASSEMBLY (#4), with the COLLAR (#3) in
place, so that the HANDLEBAR is facing away from the user. Slide
the HANDLEBAR ASSEMBLY into the HANDLEBAR POST. Be
careful not to pinch the wires.
Align the three holes in the HANDLEBAR ASSEMBLY (#4), with those
in the HANDLEBAR POST and install the three HANDLEBAR BOLTS
(#1).
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRES WHEN
PASSING THE BOLTS THROUGH THE HOLES. TIGHTEN THE
7. Slide the COLLAR (#3) down until it completely covers the
HANDLEBAR ASSEMBLY HARDWARE and the HANDLEBAR
POST. Secure the COLLAR by squeezing the sides and pushing
downward firmly.
BOLTS SECURELY.
B
A
1
5
8P
4
1
4
3