Life Fitness Lifecycle C3 Assembly Instructions Manual page 7

8. Press down on the two tabs on the top of the battery door located on
the back of the DISPLAY CONSOLE.(C) While the two tabs are
depressed, pull the BATTERY DOOR (D) away from the DISPLAY
CONSOLE.
Gently pull the BATTERY WIRES (E) from the back of the DISPLAY
CONSOLE and connect them to the 9-VOLT ALKALINE BATTERY
(#6). Carefully, tuck the BATTERY WIRES back into the DISPLAY
CONSOLE and set the BATTERY in place.
NOTE: ONLY USE AN ALKALINE TYPE BATTERY.
USE OF ANY OTHER TYPE BATTERY MAY RESULT
IN A MALFUNCTION OR DAMAGE.
Re-install the BATTERY DOOR by inserting the two bottom tabs of the
BATTERY DOOR into the corresponding slots in the DISPLAY
CONSOLE. Swing the BATTERY DOOR up and into place and press
each tab separately until they are locked into place.
9. After placing the Lifecycle exercise bike in the intended location for
use, check the stability of the bike.
If the bike is not level, rotate the FOOT in the STABILIZER BAR that
appears to be higher until the Lifecycle is level.
Secure the position of the FOOT by tightening the LOCKNUT with the
enclosed wrench.
C
E
D
6
FOOT